file type: .doc verified by: ebookebook
source title: MULTISIM
source description: Frequency Counter; It measures the frequency of an ac ... and A 3 and LOW on outputs A 1 and A 2, which is the BCD code (1001) for decimal 9. 3.9 Edge-Triggered Flip-flop
file type: .doc verified by: sisamagrooter
source title: Pinouts
source description: 7476 JK flip-flop with Preset and Clear. 74151 8x1 multiplexer (data selector) ... 74192 BCD Counter. 74193 4-Bit Binary Counter. 74192/74193 Synchronous Up/Down ...
Digital Electronics - OSWEGO
file type: .doc verified by: pmorganic
source title: Digital Electronics - OSWEGO
source description: 4.1 Binary Coded Decimal To Seven-Segment Display Decoding. 4.2 Creating the Truth ... Draw and label a circuit diagram of a ripple counter using J-K Flip Flop
file type: .doc verified by: Janaka D
source title: EE268LabManual
source description: The 74LS47 BCD to 7-segment decoder will drive a 7-segment LED ... Counter from appropriate flip-flop circuits. Required Equipment: The MultiSIM software. 74LS series ...
file type: .doc verified by: mjeffers
source title: Learning Objectives:
source description: A D-type flip-flop can be used to make up a counter. The following block diagram shows the basic ... down, rising edge triggered, falling edge triggered, binary coded decimal ...
file type: .doc verified by: tbrown128
source title: B
source description: c) Up/Down counter using JK flip flop. d) Up/Down counter using 7493. B) MICROPROCESSOR (Software) ... Modeling a BCD Counter (Top level behavioural) Writing a Test Bench for a ...
file type: .doc verified by: edjiro_77
source title: Digital Systems
source description: ... Timing State, Asynchronous inputs, Master/slave flip-flop ... subtraction, Multiplications and Division, BCD ... Counter / Shift register ICs . and Counter/Shift ...
file type: .doc verified by: chris_about
source title: LAB 2
source description: Each flip-flop is fed by an AND-OR network (essentially a 2-to-1 ... For a 2-digit BCD (Binary Coded Decimal) counter, we use an 8-bit output, but divide the range ...
Schedule of Experiments from Buchlas Digital Electronics
file type: .doc verified by: im_xyz
source title: Schedule of Experiments from Buchlas Digital Electronics
source description: ... 5th later edns) to make a binary to BCD ... 15 (5th 6th edns) - The D Latch and D flip-flop. ... You can also build a ripple counter with D type flip-flops, as ...
PLL synthesizing oscillator (3)
file type: .doc verified by: rschwertley
source title: PLL synthesizing oscillator (3)
source description: The BCD(Binary Coded Decimal) switch is used to change the frequency ... The oscillation circuit and the binary counter which was equipped with the flip-flop of the 14 ...